This post if for all of you which have any type of problem about the new method for unlock ALL Liteon DG-16D4S (Winbond or MXIC).
Post here all your problem, so we can help you to resolve the issues.
Visualizzazione Stampabile
This post if for all of you which have any type of problem about the new method for unlock ALL Liteon DG-16D4S (Winbond or MXIC).
Post here all your problem, so we can help you to resolve the issues.
by numerous reports:
2 major issue after drilling is tray will not eject and laser is not shooting.
still waiting for the next e-tool
Eject [URL="http://www.consoleopen.com/forum/tutorial-modchip-e-hardware-xbox-360-xbox360-slim/357-eject-fix-after-winbond-unlock.html"]can be solved looking here[/URL]
another problem report:
before drill = 8C
after drill = 3C
cannot unlock, it gives false unlock <00 status> but after powercycle gets back to 3C.
locking back to 8C and re-unlock cannot help, still stuck with 3C status.
... notifing Geremia right now.
thank you raiden
Tell us if this trick solve your problem...
We need details... is the drive a recent one, MT serial, controller sata, exact procedure used ?
drive is 0225.
MT1335WE winbond
lizard
exact procedure
write down all the numbers you find on the mt pls
try also on a pc with geremia's tool, not lizard, then report here status register2 value (this is very important)
Nice have you a photo of "drill work"?
MT1335WE
1051-BLSL
CUG08133
05XC60352V80002
MT1335WE
1048-CMSL
BTP4N714
05XC60301T00002
status register = 3C
sata controller NForce 650i
winbond after unlocking, tray problem --> solved, but no reads discs....
Ok, we have some more test results... 3 liteons with MX unlocked with resistor method... laser problems
Conclusion ? 1.9 firmware bugs not directly related with winbond unlock method, we should all thank TX for telling lies about damages with wb unlock method while hiding firmware problems ...
How to confirm this ? Flash back original FW (full dump).
Go out and test.
Hope 1.9 firmware is not burning lenses...
LT+1.9 have problems with open tray and play dvd.
that happens if we use dummy.bin or source_dummy.bin to make CFW
but if we use a full dump, no problem.
More and more tests on the way...
I made a test as required by reloading the original fw of my dvd drive but not read .... solutions?
Did you use mpx0 to get the drive in vendor mode ?
I thinks that too variable are in " game" this time for do a " book" with statistics
Lucky or unlucky this is a very hardware method 2 mm can be do life or death .
I had do more of 50 test with winbond chipset and Geremia method ( i'm a shop) and never a problem
If it can be from help we can start at note the winbond chipset version ( 1020 1021 ecc ecc) maybe there is a relationship between method / winbond revision
We're very glad that you post here your problem
no, using the lizard, he sent him directly to the vendor mode ...Citazione:
Originariamente Scritto da Raiden